Hardware, Mounts & Brackets
About Hardware, Mounts & Brackets
Lighting mounts and brackets hold headlights, fog lights, turn signals and marker lights in place. You need one when you change a light's style, move it, or replace a bracket that has broken. Riders look here when fitting a different headlight, relocating turn signals or hanging fog lights.
A mount is made for one light and one mounting point. The samples include headlight mounts and mounting kits listed by model, fog light mounts in chrome and black, turn signal mounts for 39 mm front forks, a turn signal relocation hardware kit for Yamaha Virago models, a custom marker light mount and a brake caliper mount for a fog light. Match the part to the diameter of the fork tube, bar or caliper bolt it clamps to, and to the size of the light. After fitting, check that the light holds steady, that wires do not pinch at full steering lock and that the beam is aimed correctly.
Brands in this category include Drag Specialties, CUSTOM DYNAMICS, Arlen Ness, MEMPHIS SHADES and HEADWINDS. The lights that go on these mounts are in Headlight Assemblies, Fog Light Assemblies and Turn Signal Light Assemblies. The whole group is Lighting & Lamps. Before you order, see why a part did not fit and how to avoid it.
FAQs on light mounts and brackets
How do I know which headlight mount fits my bike?
Headlight mounts are listed by model and year, so match those first. Also check the size and style of the headlight the mount is made to hold. If a listing names only a model code, compare it with your bike's documents or use the Ride Finder to confirm.
What fork tube size do turn signal mounts need?
Turn signal mounts are listed by fork tube diameter, such as 39 mm. Check the diameter of your fork tubes in the owner's manual or measure them, then choose the matching mount. A mount made for a different diameter will not clamp properly.
Do I need new wiring when I relocate turn signals?
Often. The signals must still reach their connectors with enough slack for the steering to turn fully. Some relocation kits include hardware and wiring, so check the listing for what is in the box and compare the wire length with your route.
How tight should light mounts be?
Tighten to the torque in the instructions or your manual, using the supplied hardware, and check the mount after the first ride, because vibration can loosen it. A loose mount lets the light shift, which changes the beam aim.
How do I aim the headlight after fitting a new mount?
Park the bike on level ground, loaded as you normally ride, facing a wall, and adjust until the beam cut-off sits at the height your manual recommends. Recheck after any change, and make sure the beam does not dazzle oncoming traffic.
